PCBCoin, 64Kb Instagram followers 2021 edition

The PCBCoin is a printed circuit board designed to look like a coin. Nearly the entire edge of the coin is gold plated, giving it a very unique look. Due to the way the plating is done, the entire edge cannot be plated. The coin can be removed from the outer holder by twisting it to break it free.

Disclaimer: Due to tolerances in the PCB fabrication process, no two PCBCoins are the same. I visually inspect each PCB to make sure that only the best coins get sent out. If you are unhappy with the coin that you receive, please let me know and I’ll make it right.

PCBCoin 2021 Specs:

• 40x40mm overall (30.5mm diameter coin)

• 1.6mm thick PCB

• 2oz copper layers

• 3u ENIG (Electroless Nickle Immersion Gold) plating

• Premium Matte Black solder mask

Removing the coin from the holder:

• You can choose to leave the coin in the holder, you do not need to remove it if you prefer.

• To remove the coin, simply push back and forth on the unsupported edges of the coin.

• The coin should break free after a few iterations.

• There will be some rough edges on the coin after removal. Use some sandpaper or a file to smooth these out, being careful not to scratch the gold edges of the coin.

• Note: The supports holding the coin in the holder are an unavoidable part of the design. They are necessary for the edge to be plated.

Note regarding International Shipping:

There are two options for shipping outside the of USA.

1. The first option is direct from me to you via USPS (usually more expensive).

2. Option two ships from France. This option is generally much cheaper, and in some cases may even be faster.